Hi-Point 995B 9mm Carbine
Disassembly, Cleaning & Assembly

Hi-Point 995B 9mm Carbine Disassembly & Assembly Instructions with photographs.

 

               

CLICK ON PICTURES FOR CLOSE-UP DETAILS

Tools needed: 8mm or 5/16" socket, Adjustable wrench, Allen wrench set, Flat screwdriver, Gun cleaning supplies

 

Disassembly:

1.     Remove the magazine.

2.     Verify gun is empty (pull the bolt back and look inside).

      

3.     Remove the charging handle and roller (unscrew the bolt head).

  

4.     Remove the front sight post. (loosen two Allen screws on bottom). The barrel shroud may come off too.

    

 

5.     Remove the receiver shroud. (remove the 2 bolts with nut inserts). The receiver shroud is the top metal part that holds the rear sights on. It will just lift off when the bolts are removed.

 

6.     Remove the top receiver shroud.

7.     Remove the barrel shroud. The barrel shroud is the long thin metal piece that covers the top of the barrel.

 

8.     Remove the barrel band screw/bolt. (unscrew it by hand if sling installed or with Allen wrench).

    

 

9.     Remove the receiver and the barrel together as an assembly by removing the bottom clip by tapping it forward with a flat screwdriver. It will push forward and come out.

              

 

10. Remove the barrel and receiver together. Pull it out of the plastic stock. If it's stuck, try pushing from the bottom at the serial number plate.

    

 

11. Remove the barrel band.

    

 

12. Flip barrel and receiver assembly face upward. Pull the back clip (backwards) to relieve the little plunger. May have to force it back by tapping with flat screwdriver or pry it back with large flat screwdriver.

              

 

13. To remove the receiver, pull back on receiver then back, a little upwards and out, then ride it out to the front of the barrel. Be careful, as the spring and plastic rod may fly out if not controlled.

         

 

14. Remove the recoil spring with plastic insert. (the plastic insert faces forward towards the muzzle of the gun).

 

15. Take the little plunger off (slide it out).

         

 

16. Tip the bolt backward to get the (2) springs and firing pin out. Carefully note the order of the parts for re-assembly. The small spring goes inside the larger one.

 

17. Clean and lube all removed parts.

    

 

 

Assembly:

1.     Install the firing pin and two springs.

2.     Install the little plunger.

3.     Install the recoil spring with plastic insert. (plastic insert faces forward towards the muzzle of the gun).

4.     To install the receiver, ride the receiver over the front of the barrel, make sure the recoil spring is compressing properly, push the receiver up and over and down and the little plunger snaps into place.

5.     Push the back clip forward. May have to tap into position. Make sure plunger is locked in.

6.     Slip the barrel band onto the barrel.

7.     Insert the barrel and receiver assembly together into the plastic stock.

8.     Install the bottom clip by tapping it rearward with a flat screwdriver. It will push back and lock flush).

9.     Install the barrel band screw/bolt.

10. Install the barrel shroud.

11. Install the receiver shroud. (install the 2 bolts with nut inserts).

12. Install the front sight post. (tighten two Allen screws). Orient with small bolt head facing forward.

13. Install the charging handle and roller (tighten with wrench).

14. Perform functional test. Rack the bolt a couple times. Test fire. Install and eject magazine. Verify capability to lock the receiver open.

 

(body)